● Australia

  E Series Slimline
     
 
 

FEATURES & BENEFITS

• Slim & stylish design

• Manufactured in Norway since 1947

• Safe

• Completely silent

• Accurate temperature control with electronic thermostat

• Economical

• Clean

• Efficient

• Healthy

• Unobtrusive

• Ideal for sufferers of asthma, hay fever, and allergies.

• Combined radiant and convection heat provides gentle and even warmth.

• Optional legs with castors available for all models

• Full 7 YEAR manufacturer’s warranty plus an outstanding 10 YEAR manufacturer’s warranty on the heating element.

 

 

  
NOBØ E4EU With Timer
 

  • Fully programmable 24 hour/ 7 day digital timer.

  • Power failure memory back up of 150 hours with internal rechargeable ni-cad battery.

 

  

Advantages Of NOBØ Slimline Radiant Panel Heaters Compared To Other Brands
 

  • Attractive, modern, clean face

  • Slimline – only 50mm thick

  • Power point can be out of sight behind heater

  • Heater can be installed behind low furniture

  • Safer low surface temperature on the panel front

  • Independent running costs documented and available

 

  
  Infrared Image
 

 

  • Left heater: NOBØ ‘E’ Series flat front panel. Heat is evenly dispersed over a large surface area. Warm but safe to touch.

  • Right heater: Front grill of convection heater. Excessive, concentrated heat is evident around the grill near the top front of the heater. This hot spot is a danger to young or frail skin.

 

  
  Selecting Your NOBØ Heater

 

MODEL E4E

MODEL E4EU WITH TIMER

WATTS

AMPS

LENGTH (mm)

HEIGHT (mm)

THICKNESS (mm)

APPROX AREA HEATED (M2)

APPROX RUNNING COST (Cents per hour)

SUGGESTED PLACEMENT

E4E05

E4EU05

500

2.08

475

400

50

5

3.1

Personal Space / Under Desk

E4E07

E4EU07

750

3.12

625

400

50

7.5

4.5

Small Ensuite

E4E10

E4EU10

1000

4.16

775

400

50

10

6

Bathroom / Bedroom 3 or 4

E4E12

E4EU12

1250

5.20

975

400

50

12

7.5

Bedroom 2 / Smaller Bedroom 1

E4E15

E4EU15

1500

6.25

1125

400

50

15

9

Average Bedroom 1

E4E20

E4EU20

2000

8.33

1525

400

50

20

12.5

Large Bedroom / Living Area

E2E12

Skirting Model No Timer

1250

5.20

1525

200

50

12

7.5

Bedroom 2 / Smaller Bedroom 1

 
 

Note (1): The table above is a guide only. To accurately determine the NOBØ panel for your heating requirement, refer to the eight page ‘information kit’, available from your NOBØ dealer or www.nobo.com.au.

Note (2): Running costs are calculated on an average National tariff of 12.5 cents per KW hour and assumes cycling of 50%. Power costs range from approximately 6.5 cents to 18.5 cents per KW hour depending on the area.

  
 
  Important Facts On NOBØ Slimline Radiant Panel Heaters
 

 

The front panel surface will not burn even young or frail skin. Tamperproof thermostat covers, switch covers and even very low surface temperature covers are available, making NOBØ ideal for kindergartens, schools, public access areas and aged care accommodation.

 

After an initial warm up, when the selected comfort temperature is achieved, the heater will cycle on the thermostat, economically maintaining the set temperature. Independent tests confirm thermostat cycling results in savings in power costs of up to 50%.

 

To achieve this, doors and openings leading from the area to be heated must remain closed.

Your decision to adequately insulate your home (in particular the ceilings) and to install lined curtains and floor coverings, will reward you with lower running costs. Rapid warm ups means that you operate your heater only when you need the warmth in that room or area, saving energy and reducing running costs. As NOBØ has no fan, 100% of the total power input is converted to heating output.

 

  
  Installation
 

 

Installation instructions are included with every NOBØ heating panel. Please ensure that the installer reads and follows these instructions.

 

Installation is quick and easy. NOBØ slimline radiant heating panels simply plug into a standard 10 amp power point.

 

All NOBØ panels are supplied with a metal mounting bracket (installation template) and 1500mm of power flex to a flat three pin plug. Heaters are installed a minimum 70mm above the room floor.

The power point may be located behind the panel resulting in a clean uninterrupted installation. The mounting bracket also allows the panel to be hinged forwards for cleaning.